How much to set aside for taxes as a freelancer, from your own numbers
The usual answer is 30%. For many mid-income freelancers that is close, but the real share moves with your profit and your state: it is lower at modest profit in a state with no income tax and higher at high profit in a high-tax state. Ten points of error on a six-figure year is real money, so it is worth five minutes to get your own number.
Estimate the year's profit
Start from revenue minus deductible expenses. Tax is charged on profit, so profit is the base for the estimate.
Add the federal taxes
Self-employment tax is 15.3% of 92.35% of profit (the Social Security part stops at $184,500 in 2026). Income tax applies after half of that tax and the $16,100 single standard deduction. On $90,000 of profit, with no other income, the federal total is $22,288.
Add your state
Use a rough flat rate for your state income tax. Some states, such as Texas, Florida and Washington, have none. At 5%, $90,000 of profit adds $4,500.
Divide by profit and round up
$22,288 + $4,500 = $26,788, which is 29.8% of $90,000. Round up to 30%. On a $3,000 invoice, move $900. Saving that share of every payment, not only of profit, leaves you a little ahead, because part of each payment goes to expenses.
Move the money the day you are paid
Keep it in a separate savings account that only receives these transfers and only pays tax. Your quarterly estimated payments then come out of that account, not out of checking.
For the due dates and the safe harbor, read Quarterly estimated taxes for the self-employed: dates, amounts and the safe harbor
Sources
The tax set-aside calculator
Enter your expected profit, pick your state (every state and DC has a preset rate, or type your own) and a sample invoice. Working Figures returns the percent of each invoice to move, the dollars on your sample invoice, the monthly equivalent and the federal and state split. The federal part uses the same 2026 engine as the quarterly estimator; the state part is a flat-rate approximation, and the page says so.
